...

Safe Start is live: a free 50-minute e-bike safety course, open to everyone. Get started

Bosch E-Bike Error 605: How to Fix It

Written by: Nick Cowie| November 17, 2026 | Time to read 5 min

The Bosch 605 error indicates that the temperature of your battery is out of whack in one direction or the other. If your battery overheats or gets too cold, it will stop your e-Bike from turning on. Let’s learn how to identify the error and what to do if you get it. 

More about the Author: Nick Cowie

Nick is a writer with seven years of experience in the cycling industry. In his free time, he enjoys swimming, Jiu Jitsu, and spending time outdoors.

cap going onto Bosch mid-drive motor
Keeping the temperature of your electric bike’s battery regulated is essential to its long-term health. That is why it is vital to store it in a temperature-controlled environment and avoid activity that will overheat it. A battery can become overheated from sitting out in the sun or even by using the higher assistance settings on your bike too much. Conversely, leaving the battery out in freezing temperatures can be just as bad, causing irreparable damage. 

If you notice you have a Bosch 605 error, that means that your battery shut down the bike due to extreme temperature in one direction or the other. Here is what to do if this error occurs so you can get your e-Bike back to working condition. 

👋  Welcome to Upway!

Upway is your top destination for buying and selling e-Bikes online. Discover your next e-Bike at up to 60% off retail prices, available in new or like-new condition.




What does a Bosch 605 error mean?


The Bosch 605 error is defined as a temporary safety fault that comes about as a result of a battery pack temperature error. Your BMS (Battery Management System) continuously tracks internal thermal sensors throughout the cells of the battery. Its job is to notice when any cell is above 103 degrees or below 32 degrees. If the BMS is triggered by one of these extreme temperatures, it will shut down charging and cut off motor assistance to protect the cells from permanent damage or stress. 


This error is less severe than a 602 error, but it is still considered moderate in terms of concern level. Because it is a safeguard rather than an actual component failure, you will be able to get through it without having to replace your battery more often than not. Still, you have to take the right steps of e-Bike troubleshooting to make sure your battery and motor return to working condition. 


man on an electric bike in the city


What steps can I take to fix it?


If your battery is experiencing extreme temperatures, the first thing you need to do is regulate it. Getting the temperature of the lithium-ion battery cells back to normal is the most important part of solving the error. Some more troubleshooting might be needed, and you might even need to see an expert if issues persist. 


  1. Stabilize the Temperature
    Before taking any other steps, you need to bring the temperature of your battery pack back to normal. Remove the battery pack completely and bring it into a temperature-controlled room. It should be away from direct sunlight, vents, or entryways on a dry surface. Wait 60 to 90 minutes to allow the core cells to stabilize back to a normal temperature. 

  2. On-Bike Troubleshooting
    If the code happens in the middle of an intense ride or climb, especially during the summer, inspect the battery pack’s casing for heat signatures or deformation. Bring the entire e-Bike to a shaded and ventilated area and rest for 20 minutes to allow the parts surrounding the battery to stop absorbing heat. Test the battery again to see if it has stabilized. If it works, ride in a lower assist mode to start. 

  3. Charging-Phase Conflicts
    An error might pop up in the middle of charging. This usually happens in the summer heat or when you are charging in a cold garage. To combat this, move the bike and charger to a more controlled room where the temperature is mild. Check the battery pack to see that all ventilation slots are clear. Restart the power on your bike after it sits for a bit and try charging again. 

Upway bike boxes in the warehouse


What do I do if the issue persists? 


If you are sure that you have properly regulated the temperature of your battery and have given it adequate time to cool down or heat up, you might need to perform a firmware check. Go into your Bosch e-Bike Flow app or visit a local service center to verify that the code is accurate and that a different error is not occurring. If none of this works, you can always take it to a verified Bosch dealer who will use the Bosch Diagnostic Tool to reveal any other internal problems that might be occurring. With all of these options at your fingertips, you are sure to get your Bosch 605 error resolved. 

Frequently Asked Questions

Why does a Bosch 605 error shut down the bike?

The BMS protects the battery from permanent damage when it is overheating or too cold. It does this by shutting down the system so no more extreme temperatures can reach the battery until the temperature is regulated. 

Can my riding style cause overheating? 

If you regularly use the highest assistance setting or jump to a higher setting quickly, it can lead to overheating and stress to the lithium-ion battery cells. 

Is this issue usually fixable on my own?

Yes, usually you can resolve a Bosch 605 error on your own by simply taking the battery out and waiting for a while while it regulates itself. Overheating or cooling is not usually a permanent issue unless it is left unaddressed. 

Key Takeaways


  1. The Bosch 605 error is considered a moderate occurrence: Luckily, the Bosch 605 error is not a critical one, meaning you are likely to recover full use of your battery, and it can usually be fixed on your own. 
  2. Bring it to a verified dealer if you need help: Bosch has certified dealers who use the Bosch Diagnostic Tool, which can see more information than you are capable of, to get a proper diagnosis. 
  3. Get the temperature regulated first: Before you do anything else, get the battery in a room with a regulated and mild temperature so it can return to safe operating condition. 




There is more to Explore

Visit below articles for more info about electric bikes 

battery being installed on an e-Bike

How to Extend Your Electric Bike Battery Life

man standing next to Bianchi bike

Upway E-Bike Trade-In: Find Out What Your E-Bike Is Worth

woman on an electric cargo bike

Sell Your Bike on Upway: What We're Looking For & How It Works